Miles SEX PANTHER, Manual

Page: 11 / 26

11
POWERING ON THE BOARD
1. Press the silver on/off button located on the underside of the board towards the
back left. The button will blink red when it has been turned on.
2. To turn the board off, just press and hold this button again until the light stops
blinking.
POWERING ON THE REMOTE
1. Press and hold the on/off button on the remote for 2-3 seconds. The remote
will vibrate once and the LCD screen will display the operation screen.
2. To turn the remote off, press and hold the power button again for 2-3 seconds.
The remote will vibrate once and then power off.
PAIRING/SYNCING
First Power on both the board and the remote. If they are not synced, follow these
steps:
1. Make sure both the board and remote have been powered off.
2. On the board, press and hold the power button (3*) for 6-7 seconds. The red light
on the power button will begin flashing rapidly to show it is ready to be paired.
3. Press and hold the power button (3*) on the remote for 6-7 seconds.
4. The remote will display a message that says: “Remote Pairing” and “Remote
Paired”
5. Once paired – The unit system will display KM/H and MPH
• Use the throttle (1*) to toggle your selection
• Press the power button (3*) to select
6. “Motor type” will display “HUB” and “BELT” (HUB = Direct) (BELT = PRO)
• Use the throttle (1*) to toggle MOTOR TYPE and press the power
button (3*) to select
7. “Wheel Diameter” will be displayed next
• For Standard Wheels; select 97. Next select Ratio: 2.6
• For Cloud Wheels; select 105. Next select Ratio: 2.6
• For AT Wheels, select 152/ Next select Ratio: 4.2