Electrical Connections
The valving system is designed to default to the power steering gearbox so power steering is always available even when the winch is in
use. The power source to the solenoid is not energized until the four pole quick connector plug is plugged in. Each solenoid has two black
wires, either of which can be used as a ground or for electric power. The grounds are connected to each other at the factory. The other black
wire plugs to the white and black wire in the harness (see illustration below). Determine a location on the front grill to mount the female 4
pole plug connector. If desired, the female 4 pole plug connector is connected to the winch with the top motor bolt. If you choose to take the
plug out of the box, drill four holes at your desired location and secure with screws. Attach the circuit breaker to the vehicle under the hood.
Connect all wiring as shown in illustration. Test hand control unit. Solenoids will make a slight “click” sound if connected properly.
DO NOT CONNECT POWER CABLES TO BATTERY UNTIL FINAL
STEP OF INSTALLATION!
Disc must be installed in the port that goes to the top port
on motor
Disc must be installed with cut side to motor
Fig. 2
WIRING INSTRUCTIONS
2121 Blount Road Pompano Beach, FL 33069 MileMarker.com 1.800.886.8647
PAGE 6