NOTE:
Please attach hand control box to the top motor bolt on the winch assembly
NOTE:
Must have a 34 Series Valve Adapter Kit to complete assembly.
Kit includes:
• 12 ft. lead remote control
• All hoses and fittings
• Remote solenoid activated control valve
GETTING STARTED
Typical Installation
Depending on amount of clearance between winch mount tray and winch body, attach the roller fairlead with two bolts (B-3/8 16 X 1¼ SS hex head bolt)
through roller fairlead and predrilled holes on front of winch mount tray and attach with 3/8 SS nuts (not provided) . When facing grill of truck, position the winch with
the hydraulic 2 speed levers to the left (passenger side). The Free/Low lever will be on top. In this position, 4 mounting holes will be on the bottom on any style of Mile
Marker winch.
Attach winch to winch mount tray by screwing 4 bolts (C-3/8 X 16 X 1 SS hex head bolt) and washers (D-3/8 SS washer) through the predrilled holes in
bottom of winch mount tray into bottom of winch body. Tighten to 35 ft/lbs. Make sure that you have AT LEAST 6 threads going into the winch legs,
but NO MORE THAN 10 threads going into winch leg.
Winch Mounting
CAUTION:
When replacing the capscrews or when longer bolts are required, make sure that you use bolts of Grade 5 or greater
Winch body on 9000 lb. and 10500 lb. winch has mounting holes only on the bottom. Winch body on 12000 lb. winch has four mounting holes
on front, back, and bottom of the winch. This may allow the winch to be mounted easier on some winch mounts or for other applications.
The motor on Mile Marker 2 speed winches may also be rotated in 90º increments if needed. This may allow easier installation on some winch
mounts.
CABLE MUST SPOOL OFF THE BOTTOM OF THE DRUM
Your winch should be aligned and secured to a solid part of the vehicle (front or rear) where the full rated load will be evenly distributed.
NOTE:
Mile Marker recommends the use of its mounting systems for proper winch installation and optimum winch performance. However,
when not using Mile Marker Mounting System, ensure that the mounting platform is strong enough to meet the maximum rated
load of the winch in use. Mile Marker recommends steel plates with thickness of at least 0.25”.
CAUTION:
It is essential that the mounting surface be flat and the winch is mounted such that the three major sections (Gear housing end,
drum and motor end) are in proper alignment
1. Drill four mounting holes (10mm in Dia.), if necessary, according to the bolt pattern mentioned in the winch specifications
2. Fasten the winch body to the mounting platform using the four Capscrews (3/8” x 16”) provided
3. Torque the Capscrews to about 35 ft-lb (47.5 N-m)
4. All Mile Marker mounting systems come predrilled with fairlead holes. If you are using any other mounting platforms, drill two holes for the
roller fairlead installation. Position the holes such that the fairlead opening hole stretches from the circumference of the drum to the end of
the maximum permissible layers on the drum in the direction cable is being rolled.
2121 Blount Road Pompano Beach, FL 33069 MileMarker.com 1.800.886.8647
PAGE 4