MiLAN MIL-SME801GLX, User Manual

Page: 112 / 155

106
5-4-4. Port Controls
The menu allows changing of port configurations.
State: User can disable or enable each port.
Negotiation: User can set auto negotiation mode for each port to Auto,
Nway (specify the speed/duplex on this port and enable auto-negotiation) or
Force.
Speed: User can set 100Mbps or 10Mbps speed on Ports 1 to 8. Port 9 is
fixed at 100 Mbps.
Duplex:
User can set full-duplex or half-duplex mode for each port.
Flows control: User can set flow control function to enabled (ON) or disabled
(OFF) in Full Duplex mode.
Back Pressure:
User can set backpressure to enabled (ON) or disabled
(OFF) in Half Duplex mode.
Band Width: Ports 1 to 9 support by-port ingress and egress rate control. For
example, if port 1 is set to 10Mbps, you can set it’s effective egress rate to
1Mbps and ingress rate to 500Kbps. The switch will perform flow control or
backpressure to confine the ingress rate to meet the specified rate.
In: Enter the port effective ingress rate. The valid range is 0 to 1000. The unit
is 100K.
0: disable rate control.
1 to 1000: valid rate value
Out: Enter the port effective egress rate. The valid range is 0 to 1000. The
unit is 100K.
0: disable rate control.