Page 21
The microcontroller can be also programmed with
ST-LINK V2 programmer
and
mikroProg Suite™ for ARM®
software,
Figure 3-11
. This programmer connects
with mikromedia board via
mikroProg to ST-LINK V2 adapter
.
Programming with ST-LINK V2 programmer
In order to adjust the ST-LINK™ V2 programmer
to be connected to the development system, it
is necessary to provide the appropriate adapter
such as the
mikroProg to ST-LINK V2 adapter
.
2x5 male headers should be first soldered on the
CN5 connector pads. Then you should plug adapter into
the ST-LINK V2 programmer (2x10 male header), and plug
IDC10 flat cable in male headers,
Figure 3-13
Figure 3-13:
Connecting ST-LINK™ V2
programmer
Figure 3-12:
mikroProg™ to
ST-LINK™ V2 adaper
Page 20
