Page 20
Page 21
Besides In-System programming mikromedia for ARM supports
JTAG programming
and
debugging interface. In order to use it, you have to
solder 2x10 header
to the JTAG connection
pads on the back side of your mikromedia board. It is also necessary to solder and set the
JTAG jumper,
located right next
to the JTAG connector (Figure 5-1), in order to enable this type of programming.
5. Programing with JTAG
programmer/debugger
Figure 5-1: Enabling
JTAG using jumper
