Operators Manual
1
General Safety Rules
WARNING: Read and understand all instructions.
Failure to follow all instructions listed
below may result in serious injury.
CAUTION: Do not allow persons to operate or assemble this MOM ACDC 200 until they
have read this manual and have developed a thorough understanding of how the MOM
ACDC 200 works.
WARNING: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions or situations that could occur.
It must be understood
by the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
1. Your Welding Environment
•
The welding machine is not suitable for use in rain
•
Keep the environment you will be welding in free from flammable materials
•
Always keep a fire extinguisher accessible to your welding environment
•
Always have a qualified person install and operate this equipment
•
Make sure the area is clean, dry and ventilated. Do not operate the welder in humid,
wet or poorly ventilated areas
•
Always have your welder maintained by a qualified technician in accordance with local,
state and national codes
•
Always be aware of your work environment. Be sure to keep other people, especially
children, away from you while welding
•
Keep harmful arc rays shielded from the view of others
•
Mount the welder on a secure bench or cart that will keep the welder secure and
prevent it from tipping over or falling
2. Your Welder’s Condition
•
Check ground cable, power cord and welding cable to be sure the insulation is not
damaged. Always replace or repair damaged components before using the welder
•
Check all components to ensure they are clean and in good operating condition before
use
3. Use of Your Welder
CAUTION!
Do not operate the welder if the output cable, electrode, torch, wire or wire
feed system is wet. Do not immerse them in water. These components and the welder
must be completely dry before attempting to use them.
•
Follow the instructions in this manual
•
Keep welder in the off position when not in use
•
Connect ground lead as close to the area being welded as possible to ensure a good
ground
