Mighty Seven DI-1015, User Manual

Page: 23 / 32

22
21. To Switch from PSI, KG/CM 2, and BAR
1) With the gauge ON, press and hold down the
RESET button for at least 6 seconds.
2) The current measuring unit will flash. Press
the RESET repeatedly to cycle through and
button to select the desired pressure unit.
3) The setting takes effect 5 seconds after the
display stops flashing.
22. To Set Pressure Gauge for Automatic
Shut Off
1) With gauge on, press the (+) or (-) button.
The previous data will display and the data
will flash.
2) Press and hold the (+) or (-) button to select
the desired shutoff pressure. Release the
button.
NOTICE: The number will flash while setting
the pressure. Hold the (+) or (-) button down
for about 3 seconds to enter the faster setting
mode.
3) When the desired pressure setting has been
selected, and the button has been released,
the setting will flash for approximately 5
seconds. When the flashing stops, the
pressure has been set.
4) The actual inflation pressure will now be
displayed
5) Begin inflating. The inflator will shut off when
the preset pressure is reached or 40 PSI,
whichever is lower.
NOTICE: If the preset pressure is greater
than (>40 PSI, 2.75 BAR, or 2.80 KG/CM2),
the inflator will automatically shut off when the
pressure reaches 40 PSI (2.75 BAR, or 2.80
KG/CM2). To activate the inflator, release the
lock-on button and depress it again.
NOTICE: Never set the pressure to more than
200 PSI.
Air Pressure