Frequently Asked Questions
53
The following fault message appears in the display and the
program has been cancelled
Message
Possible cause and remedy
Water intake See
The water inlet is blocked or restricted.
Check whether the tap is turned on properly.
Check whether the inlet hose is kinked.
Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
Clean the filter.
Drainage See
The drain is blocked or restricted.
The drain hose has been fixed too high.
Clean the filter and the pump.
The maximum drain height is 1 m.
Service
Waterproof syst.
The water protection system has engaged.
Close the tap.
Contact the Service department.
Service Fault F
There is a fault.
Disconnect the washing machine from the
electricity supply, either by switching it off at the
wall socket and withdrawing the plug, or by
disconnecting it at the circuit breaker.
Wait
at least 2 minutes
before reconnecting the
washing machine to the electricity supply.
Then switch the washing machine on again.
Restart the program.
If the fault message appears again, contact the
Service department.
To switch off the fault message: Turn the program selector to the
position and
switch the washing machine off.
