Installation surface
A concrete floor is the most suitable
installation surface for a washing
machine, being far less prone to
vibration during the spin cycle than
wooden floorboards or a carpeted
surface.
Please note the following points:
^
The machine must be level and
securely positioned.
^
To avoid vibrations during spinning,
the machine should not be installed
on soft floor coverings.
If installing on a wooden joist floor:
^
We recommend a plywood base (at
least 59x52x3 cm). The base should
span several joists and be bolted to
the joists and not only to the
floorboards. Check for the presence
of pipes and cables first.
If possible, install the machine in a
corner, as this is usually the most stable
part of the floor.
,
If the machine is installed on a
raised plinth, it
has to be secured
against slippage during spinning
using retaining clips (available from
the Miele Spare Parts Dept),
otherwise there is the danger of the
machine moving and falling off the
plinth.
Transporting the machine to its
installation site
To manoeuvre the machine out of its
packing case to its installation site, hold
it by the front feet as well as by the
edge of the lid where it protrudes to the
rear of the washing machine.
,
Ensure that the machine feet and
the floor are dry to prevent the
machine from slipping during the
spin cycle.
Removing the transit bars
^
To remove the left and right covers
1
. Use a screwdriver to prise out the
cover as illustrated.
2
. Pull the cover forwards to remove.
Installation and connection
49
Summary of Contents for W 1724
Page 67: ...67 ...
Page 68: ...Alteration rights reserved 1013 W 1724 M Nr 09 468 610 01 ...
