Miele W 1113, Technical Information

Page: 57 / 88

Technical Information
51
W1113, W1119, W1203, W1213 & W1215 Clothes Washers
3.8 Fault Code F15, Hot Water Intake
Symptom
During operation, this fault is not indicated via any LEDs on the
Control Panel. The program continues, however it will only use the
cold water supply.
Cause
The water supply is shut off.
Remedy
Turn the water supply on.
Cause
Water Intake Filters clogged.
Remedy
Clean the water intake filters.
Cause
Low on-site water pressure.
Remedy
Check water pressure and reprogram machine if necessary
Check on-site water pressure: The flow pressure must be at
least 1 bar. With the water supply fully open, at least 5 liters of
water should flow from the tap within 15 seconds.
If the on-site flow pressure is less than 1 bar, then it should be
increased.
If the on-site flow pressure cannot be increased, then low water
pressure can be programmed as an option.
Cause
Hot Water Inlet Solenoid Valve defective.
Remedy
Check the Hot Water Inlet Solenoid Valve.