Miele W 1113, Technical Information

Page: 55 / 88

Technical Information
49
W1113, W1119, W1203, W1213 & W1215 Clothes Washers
3.6 Fault Code F10, Water Intake
Symptom
The Check inlet LED flashes.
The Inlet Valve is closed and the program automatically ends. The
Drain Pump is activated for 120 seconds.
Cause
The water supply is shut off.
Remedy
Turn the water supply on.
Cause
Water intake filters are clogged.
Remedy
Check / Clean the water intake filters.
Cause
Low on-site water pressure.
Remedy
Check water pressure and reprogram machine if necessary
Check on-site water pressure: The flow pressure must be at
least 1 bar. With the water supply fully open, at least 5 liters
(approximately 1.25 gallons) of water should flow from the tap
within 15 seconds.
If the on-site flow pressure is less than 1 bar, then it should be
increased.
If the on-site flow pressure cannot be increased, then low water
pressure can be programmed as an option. Refer to the
Programming Mode information (070 4.1)
Cause
Defective Water Intake Valve.
Remedy
Check / replace the Water Intake Valve.