Cleaning the water inlet filter
A filter is incorporated in the intake
hose attached to the dishwasher’s shut
off valve. If your water is hard, or the
pipes contain sediment, this filter may
clog and prevent enough water from
entering the wash cabinet.
Installing an in-line water filter
^
If your water contains a large number
of insoluble substances, a filter
between the water valve and the
intake hose connection is
recommended. These filters can be
purchased from Miele.
,
The plastic valve housing on the
intake hose contains electrical
components and should not be
submerged, or run through water.
Cleaning the filter:
^
Disconnect the dishwasher from
electricity (unplug it or "trip" the
circuit breaker).
^
Turn off the water valve.
^
Unscrew the intake hose.
^
Carefully remove the rubber seal.
^
Remove the filter using needle nose
pliers and rinse under running water.
^
Return the filter and seal. Make sure
they are seated correctly.
^
Screw the intake hose back on the
water valve, checking that it is not
cross-threaded.
^
Slowly turn on the valve and test for
leaks.
Cleaning and Care
52
Summary of Contents for ULTRA FULLSIZE DISHWASHER
Page 46: ...46 ...
Page 54: ...54 ...
Page 55: ...55 ...
Page 56: ...M Nr 05 431 341 00 Alterations rights reserved G 896 Plus 1403 ...