Salt indicator
When the salt reservoir is empty, the
"Salt-PC" indicator will light, indicating
that it should be refilled with
reactivation salt.
After the reservoir has been filled, the
water softener is automatically
reactivated the next time the
dishwasher is started. The "Salt"
indicator will light during this process.
Bypassing the salt indicator
If your water is soft (below 8 gr/gal) the
salt reservoir should not be filled with
salt. The indicator will remain lit and
should be disregarded or bypassed.
^
Remove the salt reservoir cap.
Looking into the salt reservoir, you will
see the top of the float chamber on the
right hand side,
a
.
^
Using a screwdriver, carefully pivot
the float chamber towards the center
of the reservoir.
^
Using needle nose pliers, first pull the
cap,
b
, off of the float chamber, then
remove the float,
c
.
^
Replace the float chamber cap, push
the chamber back into its upright
position, and replace the salt
reservoir cap. The indicator should
not light.
Before using for the first time
16
Summary of Contents for ULTRA FULLSIZE DISHWASHER
Page 46: ...46 ...
Page 54: ...54 ...
Page 55: ...55 ...
Page 56: ...M Nr 05 431 341 00 Alterations rights reserved G 896 Plus 1403 ...
