Problem solving guide
59
Many malfunctions and faults that can occur in daily operation can be easily
remedied. Time and money will be saved because a service call will not be
needed.
The following guide may help you to find the reason for a malfunction or a fault,
and to correct it.
Some of the messages in the display are more than one line long. Touch the
or
sensor to read them in full.
The display indicates the following messages or faults
Message
Cause and remedy
000
lights up after
switching on.
Access via a code has been activated.
Enter the code and confirm the entry. Deactivate
the code if you do not wish this message to ap-
pear in the display the next time the machine is
switched on.
Finish/Cooling down
The laundry will be cooled down at the end of the
programme.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
Clean the plinth filter.
See
lights up
at the end of a
programme.
The tumble dryer is not working correctly or econom-
ically. Possible causes could be clogging caused by
fluff or detergent residue.
Please see “Cleaning and care” for notes on clean-
ing.
Clean the fluff filters.
Also check the plinth filter and clean it if neces-
sary.
To switch off the message: confirm
OK
.
You can influence when the
Clean the plinth filter. See
message lights up.
To do this, follow the instructions in “Airways indic-
ator – Settings”.
