Miele Triflex HX1 Pro, Operating Instructions Manual

Page: 52 / 208

en
52
Cleaning the pre-filter (Fig. 36–39)
The pre-filter is located in the dust con-
tainer.
Clean the pre-filter when required.
 Remove the dust container.

Remove the fine dust filter (Fig. 35).

Empty the dust container over a bin
and lift the pre-filter upwards to re-
move it.

Unlock the motor protection filter by
turning it anti-clockwise and lift it up-
wards to remove it.

Risk of damage caused by incor-
rect cleaning.
The pre-filter can become damaged
and be less effective as a result.
Do not use pointed or sharp-edged
objects to clean the filter.

Carefully knock the dust out of the
pre-filter over a bin.
Tip: Use a tool like a fine cleaning brush
to clean the inside of the pre-filter thor-
oughly.
You do not need to clean the motor pro-
tection filter. It can be removed so that
the inside of the pre-filter is easier to
reach.
 After cleaning the pre-filter, place the
motor protection filter back into the
pre-filter securely, making sure it is
properly positioned.

Lock the motor protection filter by
turning it clockwise as far as it will go.
 Replace the pre-filter in the dust con-
tainer.
 To do this, line up the guide lines on
the two sections and turn the dust
container lid back to its original posi-
tion.

Close the cover at the bottom of the
dust container, making sure it clicks
into place.

Replace the fine dust filter.

Replace the dust container on the
PowerUnit connector.
Cleaning the dust container
Clean the dust container as required.
 Remove the dust container.

Empty the dust container over a bin
and lift the pre-filter upwards to re-
move it (Fig. 36).

Clean the dust container using water
and mild washing-up liquid.
 Dry the dust container thoroughly.

Replace the pre-filter in the dust con-
tainer.
 Replace the dust container on the
PowerUnit connector (Fig. 38 + 39).
Cleaning the Electrobrush/handheld
brush (Fig. 06)
(The availability of the handheld brush
depends on the model)

Separate the Electrobrush/handheld
brush from the vacuum cleaner con-
nector.
Removing threads and hairs (Fig. 40)

Place the Electrobrush/handheld
brush upside down on a level, clean
surface.