Supervisor level
70
Anti-crease
The anti-crease function helps prevent
creasing if laundry is not going to be
removed immediately after the end of
the programme.
The drum continues to turn at intervals
for up to 30 minutes after the end of the
programme. The door can be opened at
any time during the anti-crease phase.
Factory setting: On
Suds cooling
Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a
programme with a temperature of 70°C
or higher is selected.
Suds cooling should be activated:
– to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
– where the drainage pipe is rated less
than 70°C.
Factory setting: On
"Display" switch-off status
To save energy, the display goes out
and the
Start/Stop
sensor flashes
slowly.
Changing this setting leads to increased
energy consumption.
– Off
The display will remain on.
– On after 10 min, not in current
programme (factory setting)
The display will remain on while the
programme is running but will go out
10 minutes after the end of the
programme.
– On after 30 min, not in current
programme
The display will remain on while the
programme is running but will go out
30 minutes after the end of the
programme.
– On after 10 min
The display will go out after
10 minutes.
– On after 30 min
The display will go out after
30 minutes.
