Problem
Possible cause
Remedy
Power failure
Programme
stopped
If the dryer is switched off
during a drying programme
or there has been a power
cut:
– After switching the dryer
on / power has been
restored, confirm with
OK
and start the programme
again.
Clean out airways
or
Clean the filters
appears at the
end of the
programme or
after a
programme has
been cancelled.
The dryer is not working
efficiently or economically.
Possible cause: A build-up of
fluff or detergent residues.
– Cleaning the fluff filter is
usually all that is required.
However, if the Clean the
airways message does
not go out after you have
cleaned the filter, then
also check all the
possible causes
described under "The
drying process goes on
too long or even
switches off".
To delete the fault message:
– Open and close the door,
or confirm with
OK
.
The vent ducting may be very
long, which does not
constitute a fault.
If very long ducting is used,
then programme times will be
longer and energy
consumption higher.
You can adjust the setting
which controls if or when the
check message appears.
– See "Settings menu
J
,
Clean the airways".
Programme cannot
be changed
An attempt has been made to
alter a programme while it is
in progress.
– You will need to cancel the
current programme before
you can select a new one.
Problem solving guide
38
