,
All electrical work must be
carried out by a suitably qualified
and competent person in
accordance with current local and
national safety regulations (BS 7671
in the UK).
– If the machine is connected via a
plug and socket, the plug connection
must be easily accessible. Plug
connection will also make it easier to
carry out mandatory safety checks,
e.g. after commissioning or
maintenance.
– For hard-wired machines connection
should be made via a suitable
isolator, with an on-off switch which
is easily accessible for servicing and
maintenance work after the machine
has been installed. An electrical
safety test must be carried out after
installation and after any servicing
work. It is therefore essential that the
on-off switch is easily accessible.
– When switched off there must be an
all-pole contact gap of at least
30 mA in the isolator switch.
– For extra safety it is advisable to
protect the machine with a suitable
residual current device.
– The mains connection cable may
only be replaced by an original Miele
spare part or an appropriate cable
with wire end ferrules.
– Check that the phase rotation is
correct when connecting the
machine. Failure to do so could have
an adverse effect on the circulation
pump and impair the wash quality.
– Equipotential bonding must be
carried out.
– For technical data see data plate or
wiring diagram supplied.
The machine must only be operated
with the voltage, frequency and fusing
shown on the
data plate
.
The
wiring diagram
is supplied with
the machine.
WARNING
THIS APPLIANCE MUST BE
EARTHED
Bonding connection
There is a screw connection point
marked with the earth symbol (
8
) at
the back of the machine, to which the
earth lead must be connected.
Electrical connection
66
