Warning and Safety instructions
12
Please observe the instructions in “Installation”, “Installation of the
ducting” and “Technical data”.
The accessibility of the plug must be always ensured, in order to
separate the tumble dryer from the mains. All electrical work should
be carried out only by a suitably qualified and competent person, in
strict accordance with national and local safety regulations.
If the appliance is hard wired, adequate provision must be made
on site to switch off all poles to disconnect the tumble dryer from the
electrical supply.
Do not block the gap between the bottom of the tumble dryer and
the floor with plinth facings, deep pile carpet etc. This would hinder a
sufficient flow of air to the dryer.
Do not install a lockable door, a sliding door or a door which is
hinged in the opposite direction to the dryer door.
This tumble dryer is supplied with a special lamp to cope with
particular conditions (e.g. relating to temperature, moisture, chemical
resistance, abrasion resistance and vibration). This special lamp
must only be used for the purpose for which it is intended. It is not
suitable for room lighting. Replacement lamps may only be fitted by
a Miele authorised person or by Miele Service.
Summary of Contents for PDR 908 EL Marine
Page 94: ......
