Leaf-type roller padding
To ensure smooth functioning of the ironer
and high capacity ironing, low maintenance
and long life, the leaf-type padding should
be covered with the specially made roller
cover.
,
Only iron articles up to max. 3mm
thick. Bulky fabrics, protruding buttons,
curtain weights etc. could damage the
leaf-type padding.
After commissioning
It is advisable approx. 40 operating hours
after commissioning to cut back the overlap
of the ironing cover which has occurred
through stretching, to about 50 mm overlap
and then to brush out about 50 mm of this
using a wire brush. This is to avoid damp
streaks and shadowing. The roller cover
must be the same thickness along the whole
length of the roller and fit firmly up to the
heater plate.
Washing the roller cover
Washing will remove any wax deposits and
restore the ironing cover to a softer, more
elastic and absorbent condition. It should,
however, be washed as infrequently as
possible in a Cottons 95°C programme. The
cover should be completely alkali free after
the last rinse.
Do not treat with acidic agents. Do not spin
at too high a speed to avoid the danger of
creasing.
Removing the ironer cloth
^
Raise the pick-off attachment upright.
^
Press
s
to switch the machine on.
^
Select the slowest speed setting.
^
Use the Forwards run
Ü
or Reverse run
Ä
button to turn the roller until the end of
the ironing cover is visible at the feed-out
side of the roller.
^
Turn the end of the ironing cover to the
feed-in side.
^
Press the Reverse run
Ä
button and let
the cloth roll out.
^
When removing the ironing cover pull
slowly and carefully away from the
grippers on the leaf-type padding.
Cleaning and care
20
M.-Nr. 05 567 240 /03
Laundry
feed-in
Cloth end
Cloth
leading
edge
Summary of Contents for MM 50-175
Page 2: ...2 M Nr 05 567 240 03 ...
Page 26: ...26 M Nr 05 567 240 03 ...
Page 27: ...M Nr 05 567 240 03 27 ...
