^
Position the fitting bracket on this
middle line. Use the indented mark
on the bracket to guide you.
^
Fit one screw
a
into the centre of the
first long slot.
^
Check the alignment with the front
edge of the unit and with the middle
line, and then fit another screw
a
into
the other long slot.
^
Then tighten both of these screws.
^
Place the appliance in the housing
unit and using your hands push on
both sides of the back of the oven
interior to move the appliance into
position. It will engage in position
when it is correctly installed.
^
Check that it is correctly aligned.
^
If it is not aligned correctly carefully
pull it back out of the niche and
realign it by slightly adjusting the
position of the bracket on the long
slots.
^
When correctly aligned insert the
third screw
a
into the middle of the
bracket to prevent the bracket
moving out of position.
^
Slide the appliance into the housing
unit, and pull the cable with the plug
through the back of the unit.
^
Connect the appliance to the
electricity supply.
^
Then push the appliance right back
into the housing unit as described
above.
Installation
46
