The correct temperature
23
Temperature display
In normal operation, the temperature
display shows the
current average
refrigerator temperature
.
Depending on the ambient temperature
and the temperature setting, it can take
the appliance a few hours to reach the
temperature required and for this tem-
perature to then be shown as a con-
stant temperature in the display.
Setting the temperature
Use the two sensor buttons below
the display to set the temperature.
When you touch the sensor button
– The temperature decreases.
– The temperature increases.
The temperature value flashes while the
temperature is being set.
The following changes will be seen on
the display when the sensor buttons are
touched:
– With the first touch: The
last temper-
ature set
flashes.
– Each subsequent touch: The temper-
ature changes in 1° increments.
– Keeping your finger on the sensor
button: The temperature changes
continuously.
Approximately 5 seconds after the last
time a sensor button was touched, the
actual
temperature inside the appliance
will automatically be displayed.
Or
Touch the OK button to confirm the
selection.
If you have adjusted the temperature,
wait for approximately 6 hours if the
appliance is not very full and for ap-
proximately 24 hours if the appliance
is full
before checking the temperature
display. It will take this long for an accu-
rate reading to be given.
If, after this time, the temperature is
still too high or too low, adjust it
again.
Temperature range
The temperature in the refrigerator sec-
tion can be set between 37°F (3°C) and
49°F (9°C).
