Hob with frame or bevelled edge
42
Installation
Preparing the worktop
Make the worktop cut-out as shown
in the building-in diagram. Observe
the safety distances (see “Safety dis-
tances”).
Seal the cut surfaces with a suitable
sealant to avoid swelling caused by
moisture. The sealant must be heat-
resistant.
Make sure that the sealant does not
come into contact with the top of the
worktop.
The seal underneath the hob will hold
it securely in the cut-out. Any gap
between the frame and worktop will
reduce with time.
Installing the hob
Attach the seal provided underneath
the edge of the hob.
Feed the mains connection cable
down through the cut-out.
Place the hob centrally in the cut-out.
When doing this, make sure that the
seal under the hob sits flush with the
worktop on all sides. This is import-
ant to ensure an effective seal all
round.
If the seal does not meet the worktop
correctly on the corners, the corner ra-
dius (
≤
R4) can be carefully scribed to
suit.
Do not use sealant (e.g. silicone).
Connect the hob to the mains.
Connect the hob to the gas supply
(see “Gas connection”).
Secure the hob (see “Securing the
hob”).
Summary of Contents for KM 2356-1
Page 62: ......
Page 64: ...M Nr 11 138 720 00 en GB KM 2356 1 KM 2357 1 ...
