The correct temperature
25
Temperature display
In normal operation the upper temper-
ature display shows the
average, cur-
rent temperature in the refrigerator
section
and the lower temperature
display
the highest temperature in
the freezer section
.
Depending on the ambient temperature
and the temperature setting, it can take
the appliance a few hours to reach the
temperature required and for this tem-
perature to then be shown as a con-
stant temperature in the display.
Setting the temperature
Use the
and
arrow sensors to
set the temperature higher or lower.
The following information shows in the
display while the sensors are being
touched:
– Touching a sensor once: the
last
temperature selected
flashes.
– Each subsequent touch of the
sensor: adjusts the temperature
shown in 1 °C increments.
– Keeping a finger on the sensor
changes the temperature continu-
ously.
Approximately 5 seconds after the last
time a sensor has been touched, the
current
temperature inside the appli-
ance is automatically shown.
Temperature range
– The temperature in the refrigerator
section can be adjusted from 3 °C to
7 °C.
– The temperature in the freezer sec-
tion can be adjusted from -14 °C to
-26 °C.
Tip:
If you have adjusted the temperat-
ure,
wait for approx. 6 hours if the ap-
pliance is not very full and for approx.
24 hours if the appliance is full
before
checking the temperature display, as it
will take this long for the appliance to
give an accurate reading.
If, after this time, the temperature is
still too high or too low, you will need
to adjust it again.
Temperature in the PerfectFresh zone
In the PerfectFresh zone the temperat-
ure is automatically maintained between
0 and 3 °C.
However, if you would like it to be
warmer or colder, e.g. when storing
fish, you can adjust the temperature
slightly.
How to adjust the temperature in the
PerfectFresh zone is described in “Se-
lecting further settings - Adjusting the
temperature in the PerfectFresh zone ”.
