Miele Imperial DWW 1250, Operating And Installation Manual

Page: 36 / 40

External fan version
Installation:
Depending on the model involved, exter-
nal fans can be installed on an outside
wall, on a pitched roof or in a suitable lo-
cation indoors.
Model DV 1100
Model DV 1005/1
Model DV 1005/1G
– For installation on a pitched roof, con-
sult the roof tiler beforehand.
Model AWG 1100
Model AWG 1005/1 - 1005/1G
– Installation on an outside wall:
First unscrew the sheet metal screws
attached to the sides then remove the
housing case.
Fit the flexible hose or exhaust duct
on to the suction socket, and feed
through a prepared opening in the
wall, together with the power cable,
and make connection with the hood.
Then fix the fan to the wall.
Put back the housing case and se-
cure with the sheet metal screws.
Model MG 1100
– Installation in an outside wall
Make a hole in the external wall as di-
rected in the installation instructions
for the wall fan.
Remove the four fixing screws and
take off the housing lid. Mark where
the holes for the screws are to be
drilled. Then drill the holes and insert
plugs.
Screw the housing together.
Position the interior telescopic part
and insert foam into the intervening
space. Secure the stainless steel lid to
the housing.
Fit the extraction flexible hose and
connect the control cable connectors
together, (if an extension is needed
use the connection cable supplied).
Models ABLG 940/1
– Other suitable location
These fan units can be installed at
any suitable location indoors and se-
cured by means of the four holes
drilled in the base plate. Connection
to the hood as well as any possible ex-
tension behind the fan unit is likewise
made via a flexible hose or exhaust
duct.
Electrical connection:
Electrical connection is made by a
power cable connecting the fan and the
cooker hood, thus allowing the fan to
operate at four different settings.
Separate fitting instructions are sup-
plied with the external fan.
External fans
36