Miele HS19, Operating Instructions Manual

Page: 74 / 260

en
7
4
You can read more about this in “Bat-
tery charging state indicator (while
charging)”.
Charging the battery (with wall
mounting) (Fig. 12)
There are 2 ways to store and charge
the vacuum cleaner in the supplied wall
bracket.
Before charging the battery for the first
time, you must read the information in
“Installation and connection – General
battery information”.
You will need a suitable location near
a free power socket for mounting the
appliance on the wall.
Wall mounting (Fig. 13 + 14)
The supplied wall bracket has a mount-
ing plate with a bag of screws attached
to the back.
Attach the mounting plate to the point
on the wall where you want the wall
mounting to be.
 Remove the bag of screws.

Press the release catch at the bottom
of the wall bracket (Fig. 13).
 Remove the mounting plate from the
wall bracket by sliding it downwards
(Fig. 14).
Attaching the mounting plate
(Fig. 15 + 16)
2 plugs and 2 T20 TORX screws are
supplied for attaching the mounting
plate to the wall.
You will also need a battery-operated
screwdriver or a drill (with a drilling dia-
meter of 6 mm).
Depending on how you decide to con-
figure your vacuum cleaner, select a
distance of 45 cm or 98 cm between
the bottom edge of the mounting plate
and the floor (Fig. 15).
Be careful not to damage any cables
laid in the wall.

Attach the mounting plate to the wall
(Fig. 16).
Attaching the charging cable to the
wall bracket (Fig. 17, 18 + 19)
A cable compartment is located on the
underside of the wall bracket.

Press both release catches on the un-
derside of the wall bracket and re-
move the cable compartment cover
(Fig. 17).
 Plug the supplied charging cable into
the opening from above (Fig. 18).
 Lay the charging cable in its guide
(Fig. 18).

Refit the cover and lock the cable
compartment (Fig. 19).
Connecting the accessories holder (if
required) (Fig. 20)
An accessories holder is supplied for
storing the 3-piece accessory set on
the wall bracket (see “Using the ac-
cessories supplied”).

Push the accessories holder onto the
wall bracket as far as it will go.
Connecting the wall bracket
(Fig. 21 + 22)

Slide the wall bracket down into the
mounting plate from above until it
audibly clicks into place (Fig. 21).