Miele G 8072, Operating Instructions Manual

Page: 26 / 52

Measuring the cleaning agent
If your machine is fitted with a liquid
dispensing system, and you want to
programme it yourself:
^
The dishwasher must be switched
off; if not, press the
[
control to
switch off.
^
Press and hold controls Ä and
X
together, and at the same time switch
on the dishwasher by pressing
[
.
^
Press and hold control { . The value
of the last cleaning agent
concentration will show in display ~ .
^
Press and hold { and
X
. The
operating hour that the current
cleaning agent concentration was
last programmed will show in the
display.
^
Press and hold | . The value of the
penultimate cleaning agent
concentration will show in display ~ .
^
Press and hold | and
X
. The
operating hour that the cleaning
agent concentration was
penultimately programmed will show
in the display.
Changing the brand of liquid
cleaning agent
If you change the brand of your liquid
cleaning agent, you should rinse the
system out with fresh water, even if the
new cleaning agent is made by the
same manufacturer.
Otherwise there is a risk of the
dispenser pump breaking down due to
crystallisation arising from the mixing of
different agents. Proceed as follows:
^
Remove the siphon, and place in a
container filled with fresh water.
^
Press control Ä for 3 seconds to
drain the dishwasher with the
self-cleaning programme. It will
switch off automatically.
^
Press control
[
.
The heating up phase will begin.
The programme control
X
will light
up red. The boiler and tank will fill up
with water, and the water will heat up.
Control
X
will light up green when
the filling and heating phase is
complete. Cleaning agent will not be
dispensed during this procedure.
^
Press control Ä for 3 seconds to
drain the dishwasher with the
self-cleaning programme. It will then
switch off automatically.
Venting and programming the dispensing system
26