^
Undo screws
e
and take hinge plate
f
off.
^
Unscrew bearing
g
from hinge plate
f
, rotate it by 180° and refit into the
hole on the opposite side of the hinge
plate.
^
Place cap
d
in the other hole.
^
Unscrew and remove grub screw
c
using the Allen key supplied.
^
Fit grub screw
c
on the hinge plate
on the opposite side so that it is flush
with the hinge plate on the outside.
The end of the grub screw must
protrude from the hinge pin hole
enough so that it can fit into the
groove in the hinge pin (see picture).
^
Remove cover
h
, rotate it by 180°
and fit it into the holes on the
opposite side.
^
Undo screw
i
and screw it into the
outermost hole on the other side.
^
Screw hinge plate
f
into position on
the opposite side using the two
outer
long slots only. Do not use the
middle
screw because you will not
be able to align the door over the
outer long slots later on.
^
Place the entire hinge pin
a
with the
disc
b
and groove onto the end of
the grub screw and screw in hinge
pin.
^
Then tighten grub screw
c
.
Changing the door hinging
51
