Problem
Possible cause
Remedy
Demo mode has been
set and the appliance
does not heat up.
Select and confirm
"Settings - Showroom
prog. - .Off."
The fan can still be
heard after the
appliance has been
switched off.
The appliance is fitted
with a fan which removes
steam from the oven. The
fan continues to run even
after the appliance has
been switched off.
This is not a fault.
The fan switches off
automatically after a
certain period of time.
The water container has
become harder to put
into the appliance and
take out again.
The coupling seal on the
water container is stiff.
Lightly lubricate the
coupling seal with
silicone grease, as
described in "Cleaning
and care - Coupling seal".
The heating-up phase
lasts an unusually long
time.
A layer of limescale has
built up in the bottom of
the water container as the
water hardness level has
not been set correctly.
Set the appropriate water
hardness level for the
mains water supply (see
"Settings - Water
hardness", and descale
the appliance as
described in "Descale".
If the correct water
hardness level was
already set, or if the
problem recurs, call the
Service department.
After moving house the
appliance no longer
switches from the
heating-up phase to the
cooking phase.
The boiling temperature
of the water has changed
as the altitude of the new
location for the appliance
differs from the old one
by at least 300 m.
To adjust the boiling
temperature, descale the
appliance (see "Cleaning
and care - Descale").
Problem solving guide
64
Summary of Contents for DGC 5051
Page 74: ...74 ...
Page 75: ...75 ...
Page 76: ...Alteration rights reserved 4709 M Nr 07 671 650 00 ...