Electrical connection
41
Installation, repairs and other work
by unqualified persons could be
dangerous. The manufacturer cannot
be held liable for unauthorised work.
All electrical work should be
undertaken by a suitably qualified
and competent person in strict
accordance with current national and
local safety and building code
regulations.
The rangehood must be connected to a
mains electricity supply which
conforms with current local and
national regulations.
For extra safety, it is advisable to install
a residual current device (RCD) with a
trip current of 30 mA.
Connection of this appliance should be
made via a suitable isolator which
complies with national and local safety
regulations and the On-Off switch
should be easily accessible after the
appliance has been built in. When
switched off, there must be an all-pole
contact gap of 3 mm in the switch
(including switch, fuses and relays
according to EN 60335).
The connection data is given on the
data plate (See "After sales service").
Ensure that this data matches the
household mains supply.
If a flexible connection cable is being
used to connect the appliance to the
electricity supply, the cross-sectional
area of the the individual leads must be
between 0.75 mm² and 1.5 mm².
The strain relief must be used to ensure
problem-free connection.
Summary of Contents for DA 390-6
