Miele DA 3060, Operating And Installation Manual

Page: 21 / 36

Positioning the appliance in
the wall housing unit
To position the appliance correctly,
cut the spacer strip to required depth
T, and then attach it to the back of
the appliance.
T = Depth of carcase K minus depth of
appliance G
^
The depth of appliance G depends
on the lightshield being used:
–
a
Lightshield to match existing
kitchen furniture
–
b
DFB lightshield (optional
accesssory)
–
c
No lightshield.
This is based on a lightshield which
aligns with the front edge of the
carcase.
If the lightshield is further forward or
back, measurement
T will need to be
adjusted accordingly.
When installing a shelf or partition wall,
the building-in space at the back must
not be less than 180 mm.
If it is less than 180 mm, position the
appliance further back, and reduce
measurement
T accordingly. The
building-in position can be rectified
later by adjusting the depth.
^
Cut the spacer strip supplied to
measurement
T .
Score along the groove for the
smaller measurement as shown, and
remove the surplus.
^
Screw the spacer strip to the bottom
of the sides of the housing, flush with
the rear wall.
^
Draw a vertical line up both inside
walls of the housing from the front of
the spacer strip.
Installation
21