Miele DA 3060, Operating And Installation Manual

Page: 14 / 36

Cleaning the grease filters by hand
^
Clean the filters with a soft nylon
brush in a mild solution of hot water
and a small amount of washing-up
liquid.
Do not use undiluted washing up
liquid.
Do not use:
– cleaning agents containing
descaling agents,
– powder cleaners, cream cleaners or
abrasive all-purpose cleaning
agents,
– oven sprays.
Cleaning the grease filters in the
dishwasher
^
Place the filters as upright as
possible in the lower basket, with the
short sides upright. Make sure that
the spray arm can move freely.
^
Do not wash at more than 65° C. If a
Miele dishwasher is being used,
select the Sensor wash programme.
^
Use a mild dishwasher detergent.
Depending on the cleaning agent
used, cleaning the filters in a
dishwasher can cause permanent
discolouration to the surface.
However, this will not affect the
functioning of the filters in any way.
^
After cleaning, leave the filter to dry
for a while on an absorbent surface
before putting it back in place.
^
When removing the filter for cleaning,
also clean off any residues of oil or
fat from the now accessible housing
to prevent the risk of these catching
fire.
^
When putting it back, make sure that
the
red plastic guides are at the
front and facing upwards.
^
Replace the grease filter in the front
of the deflector plate, press it
upwards and push it in together with
the deflector plate. It will slide onto
the fixing pins at the back. Finally,
push the grease filter back a little
more.
Cleaning and care
14