Miele professional WS 5240, Operating Instructions Manual

Page: 20 / 52

Problem solving guide
First position the screwdriver in the opening,
push in and hold firm.
Press against the door handle with your right
hand, and then pull on the door handle to
open the door.
- Never use force to open the door. -
Take out the laundry.
Fault messages
Repairs to machines should only be under-
taken by a suitably qualified service engineer
to ensure safety. Unauthorised repairs could
be dangerous.
Faults that occur before or after the start of a
programme are displayed in a flashing display.
When power is restored press the Start
button
X
.
This fault message can also indicate that the
winding protection of the drive motor has over-
heated. Allow the motor to cool down.
Should the water inlet become blocked,
"Water inlet fault" will be displayed and the
programme terminated.
Open water stopcock and press the Start
button
X
.
Check the drainage system on site and press
the Start button
X
. A defective drain valve
should only be repaired by an authorised
service engineer.
Call the Service department.
Call the Service department.
Call the Service department.
Call the Service department.
PROGRAMME 1 Universal 50°C
PROGRAMME STOP
THROUGH POWER CUT
Please press the Start button.
PROGRAMME 1 Universal 50°C
PROGRAMME STOP
WATER INLET FAULT
Open water stopcock and press Start button.
PROGRAMME 1 Universal 50°C
PROGRAMME STOP
HEATING SYSTEM FAULT
PROGRAMME 1 Universal 50°C
PROGRAMME STOP
HEATING SYSTEM FAULT
Cut-out of heating sensor 1.
PROGRAMME 1 Universal 50°C
PROGRAMME STOP
HEATING SYSTEM FAULT
Short circuit on heater sensor 1
PROGRAMME 1 Universal 50°C
PROGRAMME STOP
DRAIN FAULT
Clean drain system and press Start button.
PROGRAMME 1 Universal 50°C
PROGRAMME STOP
DRIVE SYSTEM FAULT
Multiplug drive variants lacking.
«M.-Nr. 06 411 840 - GB - » 20