Setup - 6
Midway Games West Inc.
INSTALL PLAYER CONTROLS
1.
TEMPLATE
If control panel template is creased, flatten with a stack of books, newspapers, magazines, etc.
2.
Remove buttons, joysticks, or other controls from control panel. Remove covering and artwork, hinges or
mounting brackets.
3.
Fill holes with suitable material (i.e., wood putty, glue, etc.). Let dry. Sand or file flat both sides of surface.
Should you choose to replace the control panel board, it must match the original panel in size and thickness, and
include all fastening and grounding hardware.
4.
Tape template on top of panel. Orient template to center controls. Cut and deburr holes. Remove template.
NOTICE: If existing game already has a recessed area where the joystick will go, you may not
need to cut a new hole.
5.
DECAL
Remove backing and apply control panel decal to panel. Work down from top. After decal is in place,
smooth it outwards, squeezing out air bubbles. Pop persistent air bubbles and smooth decal.
6.
Let adhesive set. Trim decal edges and cut joystick, button, and keypad holes to fit control panel.
7.
BUTTON DECALS
Position control decals next to appropriate holes in the following order:
a.
Camera
b.
Select Club
c.
Turn
d.
Extreme Mode rectangular overlay
e.
Start/Select
f.
Troon logo
g.
Midway logo
8.
OVERLAY
Place plastic overlay on top of panel decals. Deburr overlay edges. Tape control panel template on
top of overlay in same position as holes beneath overlay. Cut and deburr holes. Remove template. Fasten
overlay with included hardware.
NOTICE: Some games require you to cut out a circle rather than a rectangle for the joystick.
Observe notice on template for further instructions.
9.
BUTTONS
Disassemble each switch from its pushbutton. Bend large prong away from switch enough to slide
switch off housing. Unscrew nut from housing.
10.
Insert pushbutton housing through a button hole from top of control panel. Screw nut finger tight on switch
housing from underside of panel. Snap switch back on housing. Repeat for each button.
