Skins Game Conversion Kit
Setup - 9
WIRE CABINET
CAUTION: ATTACH CONNECTORS PROPERLY. Be sure that printed circuit board
(PCB) connectors mate properly. If connectors do not slip on easily, do not force them. A
reversed connector may damage video game machine and void warranty. Connector
keys only allow a connector to fit one set of pins on a board.
CAUTION: OBSERVE GROUNDING. Be aware of ground wires in game. Ground wires
are usually green or green with a yellow stripe. Reuse any existing ground wires, and use
ground wires included in this kit.
1.
JAMMA HARNESS
When wiring JAMMA harness to the controls and the CPU Board Assembly, refer to
Cabinet Wiring Diagram in Wiring Chapter.
2.
Attach component end of JAMMA harness to mate on CPU Board Assembly.
3.
Attach free end of joystick adapter harness to its mate connector (P8) on the CPU Board Assembly.
4.
Attach keypad harness to its mate connector (P26) on the CPU Board Assembly. Attach the other end of the
harness to the pigtail on the keypad assembly Do not force connectors. They are keyed to fit only one way.
5.
Attach Player 4 (P4) and coin door connectors to CPU Board Assembly.
6.
Double check your connections to ensure they are all firm and secure. Do not force connectors.
7.
JOYSTICK HARNESS
Attach free connector of joystick harness to its mate connector on the joystick adapter
harness H-23480. Connect one end of green/yellow wire to joystick mounting plate and other end to safety
ground.
8.
BUTTONS
Mate each of the five small buttons and start button to corresponding JAMMA wires.
9.
Connect one end of an H-21672 ground braid to control panel and other end to safety ground on power supply.
10.
Ensure each button is connected to ground through JAMMA harness black ground.
NOTICE: Hard disk drives are sensitive to static. When not in use, store drives in anti-static
bags. Do not drop or stack drives.
11.
HARD DISK DRIVE
Mount hard drive onto hard disk drive bracket. Note that end of bracket where holes are
spaced closer together is where ribbon cable connects.
12.
Mount bracket onto studs on electronics assembly with included KEPS nuts.
13.
Connect data ribbon cable and power cable to Hard Disk Drive.
14.
Replace groundplane cover. Secure to groundplane using all but one of the enclosed nuts.
15.
Attach one end of second ground braid H-21672 to remaining groundplane post and fasten nut. Secure other end
of braid to safety ground on power supply.
16.
Replace and lock rear door.