Safety Notices
The fol lowi ng safety instructions apply to all game operators and service personnel . Specific
warnings and cautions will be found throughout this manual where they apply. We recommend
that you read this page before preparing your game for play.
AC POWER CONNECTION.
Before connecting the game to the AC power source,
verify that the " line voltage selection chart" jum per wires are instal led correctly for the
l ine voltage in your area. For details, refer to Section 3.
PROPERLY GROUND THE GAME.
To avoid electrical shocks , do not plug in the game
until it has been inspected and properly grounded. M I DWAY games should only be
pl ugged i nto a grounded 3-wi re outlet. Shocks wil l also result, if the control panel is not
properly grounded! After servicing any parts on the panel , be sure that the ground wires
are secure. Only then should you lock up the game.
DISCONNECT POWER DURING REPAIRS.
To avoid electrical shock, disconnect the
game from the AC power source before removing or repairing any part of the game.
USE THE PROPER FUSE.
To avoid electrical shock, use the replacement fuse which is
specified in the parts list for this game. The replacement fuse must match the original
fuse in fuse type, voltage rating, and current rating.
MONITOR PRECAUTIONS.
When removing or repairing the monitor, extra precautions
m ust be taken to avoid electrical shock. High voltages may exist within the monitor
circuitry and cathode ray tube (CRT) even after power has been disconnected. Do not
touch internal parts of the monitor with your hands or metal objects! Always discharge
the CRT by the following method: Attach one end of a large, well-i nsulated, 20-kv jumper
to ground. Momentarily touch the free end of the grounded jum per to the anode by
sliding it under the anode cap. Wait two mi nutes and discharge the anode again.
HANDLE FLUORESCENT TUBE AND CRT WITH CARE.
If you drop a fluorescent
tube or CRT and i t breaks, it will implode! Shattered glass can fly eight feet or more
from the implosion.
ATTENTION!
PROPERLY ATTACH ALL CONNECTORS.
Make sure that the connectors on each printed
circuit board (PCB) are properly connected. If the connectors do not slip on easily, do not force
them. A reversed connector may damage your game and void the warranty. All connectors are
keyed to fit specific pins on each board.
1-2
Summary of Contents for CRUIS'N USA
