Gasket must be properly
positioned to create seal
6b. Power supply connection - Outdoor driver
6c. Control connection - DALI - Outdoor driver
Checking the gasket
Check the gasket is properly positioned inside the lid, then close the junction box.
Secure it with 4 countersunk screws (tighten them in the order shown).
WARNING: if the gasket is wrongly positioned or screws are loose water may get into the junction
box.
Place the cover back on to the driver unit and the cap on the control plug if not needed.
Strip the rubber jacket of the cable, expose 25 mm of
conductors. Mount the TH384 – socket connector.
Match
L
RED conductor (+ pole / DA)
N
BLUE conductor (- pole / DA).
Tighten the screws and pull each wire to check if they are
well clamped. Conductor colours may vary.
Remove the plastic cap to plug the control cable (2 poles,
yellow connector).
Insert the socket into the connector housing. Tighten the
plastic nut to seal the cable with the connector grommet.
1
3
4
2
midstreamlighting.com call +44 (0) 207 584 8310
14
15
MODUS S INSTALLATION GUIDANCE
25