Tighten the nut
Tighten the nut using a 21 mm wrench
Connect the power cable
Connect the socket to the plug on the LED luminaire and
tighten the housing to ensure IP68 protection. Test the
luminaire before attaching it to the final connection point.
Connect the power cable to the connector with 'POWER'
sticker on it, and control cable to the connector with
'CONTROL' sticker on it.
midstreamlighting.com call +44 (0) 207 584 8310
8
9
MODUS 450 INSTALLATION GUIDANCE
6. Electrical connection
6. Electrical connection
Connector mounting
To mount the connector on the cable, remove the cable sheath for 25 mm. The wires do not need to be stripped
because the connector is equipped with piercing screws. If the cable diameter is great than 9 mm remove the inside
part of the grommet. To remove the gasket, remove cable gland nut first. Insert the cable through the socket housing
of the connector.
Wiring instructions
Insert each wire into the socket terminal, matching wire
colour with the 'L', 'N' and 'GND' symbol on the socket
and tighten the screws. Match:
Mains cable
Live
BROWN wire
Neutral
BLUE wire
Earth symbol
YELLOW/GREEN wire.
Dali control cable
Live
DALI+
Neutral
DALI-
0-10 V control cable
Live
Neutral
Control-
Earth symbol
12V aux (only if needed)
Insert the socket into the housing until the inner part
'clicks' in and then insert the gasket.
Self-piercing
DA1
DA2
++
=
DA1
DA2
++
=
DALI control 2 pole
0-10V control
and power 3 pole