midstreamlighting.com call +44 (0) 207 584 8310
2
3
MODUS 450 INSTALLATION GUIDANCE V1
Contents
Prior to starting the installation, check the equipment list
to be sure of using the correct tools
DO NOT USE PERCUSSION DRILLS!
30 mm standard wrench for M20 screws
21 mm standard wrench for connector cables
19 mm standard wrench for M12 screws
#8 allen key
#6 allen key
Powered drill-screwdriver with adjustable torque
(clutch)
Torx T30 insert bit for powered screwdriver (to be
used with M6 screws)
Torx T30 manual screwdriver
Monkey pliers
Electrician scissors for wires
Slotted manual screwdriver for connector’s screws
(blade dimensions: 3.5(w) x 0.6 mm)
Equipment list
Wear adequate working gloves, safety shoes and
hard hats to protect yourself from falling material
Never energize the lamp if wiring operation is not
completed
H&S check
1. General notes
Section
PAGE
1 General notes
3
2 Safety instructions
4
3 Contents
5
4 Bracket mounting and aiming
6
5
Visor mounting
7
6
Electrical connection
7
7
Electrical specifications
10
8
Weight and Windage
10
9 Dimensions
11
This user manual contains important information on safe operation of the Luminaire.
Read and follow all safety notes and all instructions. Save this manual for future reference.
Make sure that it is available to all persons using this device.
All wiring should be done by a licensed electrician in accordance with state codes, local codes, and National Electric
Code (NEC) standards or International Electrotechnical Commission (IEC) standards.
The Luminaire is suitable for out door use and wet locations.
This luminaire must only be replaced by the manufacturer, by its service staff or by qualified personnel.
IP66:
The product is protected against powerful water jets.
DO
Store the luminaire with care, avoiding placing the lenses on the ground, which may scratch or damage them
Keep the luminaire in the original packaging when storing to avoid damage
When handling the Luminaire, wear industrial safety gloves and safety boots
Operate on circuitry when the electrical power supply is disconnected
DO NOT
Do not apply mains voltage through the control system cable. This will damage the luminaire and it will no longer
be covered by warranty
Do not unnecessarily remove the luminaire from the box
Do not leave the LED luminaire switched on when resting on the ground with optics facing down
Do not place the luminaire with the lens on the ground, dirty or metal surfaces
Do not clean the lenses with any industrial detergent. Only use a water-soaked cloth if needed