2. Insert screws
Insert each screw with its plain washer and spring washer
through the central hole of the fitting bracket flange and
slightly tighten.
You will need to be able to rotate the bracket with ease to
adjust the tilt.
4. Mounting
When the LED luminaire installation has been completed,
secure the floodlight to the mounting structure via the
safety cable.
Connect the safety cable to the holding frame with the
supplied carabiner hook
.
1. Angled bracket
The floodlight is equipped with an angled bracket that
has a central hole for an M20 screw (tightening torque
250 Nm) and two slots for M12 screws (tightening torque:
80 Nm). Bracket has 2 positioning layouts.
3. Adjusting angle
The LED luminaire can be tilted at 5° intervals using the
notches on the frame and the references on the bracket.
Once the tilting operation is complete, tighten and lock
the screws (tightening torque: 50 Nm).
5°
5°
56.0
1
A 3.00
22.0
2
A 3.00
22.0
3
A 3.00
56.0
4
A 3.00
SCALE 1:1
SEE DETAIL
A
midstreamlighting.com call +44 (0) 207 584 8310
6
7
MODUS 450 INSTALLATION GUIDANCE
4. Bracket mounting and aiming
Use A2-80 stainless steel bolts or 8.8 class
steel bolts with hot dip galvanised coating
Do not use percussion drills
4.9°
5°
56.0
1
A 3.00
22.0
2
A 3.00
22.0
3
A 3.00
56.0
4
A 3.00
SCALE 1:1
SEE DETAIL
A
5. Visor mounting
Secure visor
Mount the visor on the LED module. The
visor must be secured with the supplied
screws along with the serrated washers
as shown.
Tightening torque: 7-8 Nm.
The shape of the visors may vary.
Power plug
The cable for floodlight power connection must have
3 conductors (max. diameter 12 mm, max. section
1,5 mm
2
). This should be connected to the white plug
labelled 'power'.
Control plug
Use a cable with 2 conductors for DALI control
connection (max. diameter 12 mm, max section 1,5
mm
2
). This should be connected to the yellow plug,
labelled 'control'.
Use a cable with 3 conductors for 0-10 V control
connection (max. diameter 12 mm, max section 1,5
mm
2
).
This should be connected to the white plug, labelled
'control'.
6. Electrical connection
Use a main circuit breaker
with a rated current of
at least 16 A
Do not apply mains voltage
through the control sytem
cable. This will damage
the luminaire.
Control
connector
yellow (DALI),
or white (0-10V).
Keep closed
with cap if
not in use
Power
connector
(white)