During flying,if you press headless mode button,the remote
control will emit two «beep» sound, the drone's light will blink
fast. The headless mode is enabled. If you press this button
once again, the relote control will emit one «beep» sound, the
headless mode is now disabled.
SPEED SELECTION
High/Low speed mode is controlling the speed of flying forward/backward/
leftward/rightward. The default setting is slow mode. press the «speed» button,
the remote will emit two «beep» sound,the high speed mode is selected.
Press again,this button, the remote control will emit one «beep» sound and
the drone will back to slow speed mode.
PHOTO AND VIDEO
The photos and videos are taken directly from the APP Midrone SKY 180 when the drone is
connected by WiFi to the smartphone. The photos and videos will be saved directly in the memory
of the smartphone. Press the Photo button in the APP once to take a picture. Press the Video
button in te APP once to start recording video. Press this button again to stop recording.
360° ROLLOVER (3D FLIP)
When you pilot the drone with more confidence, you can try to
perform acrobatics with style!
Fly the drone up to 3 meters height. Press and hold the 3D Rollover
button on the top right side of the remote control, and use the right
joystick to control rollover direction to achieve a 360° rollover
forward, back, left or right .
Note: This function is only available when the drone is flying without
the camera. When the camera is installed, the 360° stunt flip function
will be automatically disabled as the drone is too heavy to perform it.
If case of any emergency, an urgent shutdown is possible by
pressing deeply (more than 2 seconds) the 3D Flip button.
(see image on the left) Do not use this function when the drone
is flying normally on a high level, or the aircraft would drop down
directly and get damaged.
URGENT SHUTDOWN
LEVEL CALIBRATION
Please perform this calibration if the drone is flying unstably. This
function is making a reset the drone's gyro and of the fine
adjustments (TRIM). Before calibration, it is required to place the
drone on a flat surface. (If the landing gear is out of shape, the
reset function will be affected). Push both joysticks as shown on
the left picture, after 2 second the remote control will emit a
«beep» sound and the drone’s lights will blink fast sevral times,
the calibration is now completed.
