2. Charging and installing the Li-Po battery
Plug the USB connector of the charging cable to a USB port
on your computer or USB charger (not included), and the other
end directly to the battery cable. The charge indicator LED will
light in red on the charger.
It takes about 60 minutes for the lithium battery to be fully
charged. The red LED indicator light turns off when the battery
full.
Install the fully charged battery into the compartment provided
for this purpose below the drone and plug the cable into the drone's power plug.
INSTALLING FEET AND PROTECTIONS - REPLACING THE PROPELLERS
Install the feet and protections as shown in the picture below. Screw protections when it is in place.
If a propeller replacement is necessary pay special attention
to the direction of rotation. More details in the illustration at
right. The propellers that rotate clockwise are marked with a
letter A or with arrows. Those that rotate in the anti-clockwise
direction are marked with a letter B or with arrows.
NOTE: The installation of accessories increases the weight
of the drone and can affect the flight time.
BEFORE FLYING
Settle in a space without obstacles with a clearance of about ten meters around you and five
meters in height at least. Ensure that the battery of the drone and batteries from remote control
are fully charged.
PREPARATION FOR TAKE OFF
Connect the battery of the drone and
slide the ON/OFF switch under the drone to ON position
,
the drone LED lights flash rapidly. Then place the drone to the ground or on a flat surface and
turn on the remote control.
CAMERA INSTALLATION
Insert the camera's power plug
into the bottom of the aircraft input jack
Align the fixed rail at the bottom of the camera with the fixed rail
slot at the bottom of the aircraft, and then push it to the bottom;
when you remove the camera, press the lock on the camera to
unlock the camera before you can eject the camera.
NOTE: The 3D flip function is not activated when the camera is installed, as the drone will be too heavy to
perform acrobatics.
