Midland Atlantic, Manual

Page: 7 / 18

4. PREPARING THE TRANSCEIVER
Make sure the following items are supplied in the package before you start using your transceiver:
• transceiver;
• desk/wall support;
• belt clip holder;
• waterproof case with neck collar
• operational manual;
If any of the above is missing or damaged contact your supplier immediately.
4.1 Installing and removing the belt clip
With the belt clip you can easily attach the transceiver to your belt. The clip however, must be removed in
order to install or change the batteries. To remove the belt clip follow the instructions of picture 1. To fix the
clip back to the device slot it in the guides at the back of the transceiver until it clicks into place.
Picture 1
4.2 Installing and removing batteries
The transceiver is operated by four optional AA battery. These can be either one of two types:
•
Rechargeable NiMH (1,2 V) – available in different capacity (in mA/h). Batteries with higher capacity will supply longer charger but will
require longer times to recharge.
•
Non-rechargeable alkaline (1,5 V)
! Do not install rechargeable and alkaline batteries at the same time in your transceiver.
Always use the same batteries as a set (type and make) so that you can be sure their level of
charge is the same.
! If you do not use the transceiver for a long time remove the batteries.
4.2.a Installation
1) Remove the belt clip as explained in paragraph 4.1;
2) Open the batteries compartment as shown in picture 2;
3) Insert the batteries in the battery compartment as shown in picture 2.
7