BASIC OPERATIONS
PROGRAM SETTING
Press PROGRAM button, the current program number will appear on the display. Use +, -
button to increase or decrease the program number you desire. You can also press numerical
buttons 0 - 9 to enter the number directly ranging of 1 to 128. You must enter all 3 figures, for
example, 001, 012, 126 etc. If you don’t complete data entry by 3 seconds, the display will
recover to previous figure.
CONTROLLER SETTING
Press the Set Controller Button, then rotate or move one of the controllers (10 knobs, data
slider or modulation wheel!). The display shows the controller you choose. After a short delay
you can input the midi controller (parameter) you want to control, e.g. volume controller 07
by slider, plus/minus buttons or ten keys. Then you can input the midi channel for the
controller, but you also can leave the controller setting by pressing the set controller knob. If
you want to set the midi channel you can input by slider, plus/minus buttons or the ten keys
the channel. Then press set controller again, which stores the controller, and leave the set
controller mode.
MEMORY BANK SETTING
There are 10 memory banks to save your favourite settings. It is easy for you to recall your
setting by pressing one button. For store data on a memory bank press M.BANK button and
hold down, then press one of the 1 - 10 buttons at the same time, your settings are saved into
this button (Bank). The following settings can be saved: Controller settings, Program change,
Transpose, Octave, Velocity Curve, Volume, Reverb level, Pedal definitions, Wheel
definition, MSB, LSB, MIDI mode. To recall your settings, simply click the M.BANK button.
Then press one of the 1 - 10 buttons, settings stored in the bank will be recalled and
transmitted immediately. About 3 seconds after you complete the operation, the display will
return to indicate program number.
8
