![background image](http://html1.mh-extra.com/html/midea/ntb20-15l/ntb20-15l_owners-manual_1791063005.webp)
4
18.5cm
18.5cm
3. Set the power switch to
●
position for fast warm up of a room. Once the room
is Comfortable, select a lower setting to reduce electrical consumption and to
prevent the room from becoming too warm.
4. Adjust the thermostat to maximum and select the desired power setting. Once
the room is comfortable, rotate the thermostat counterclockwise, until the heater
shuts off. The thermostat will now maintain the temperature by cycling the heater
on or off. During particularly cold weather, the low power setting may be
insufficient to satisfy the thermostat. Select a higher setting for these periods.
1. Plug into any 220-240VAC, 50Hz source (see important safeguards section
3.3 regarding use of extension cords).
2. Your heater is equipped with a 3-position power switch:
OPERATING INSTRUCTION
FUNCTION
POWER OFF
FAN ONLY
1200 WATTS
2000 WATTS
SYMBOL
OFF
Attention:
1. The holes of the wall and the holes of the heater’s rear cover should be on the
same horizon line.
2. Keep the distance between flank wall and the heater more than 50CM, and there
is no other blockings within the distance of 60CM above and below the heater, in
order to make the heating air ventilate.
3. The mounting height should be more than 180CM.
4. When used near bathroom or swimming pool, do not drop the unit into bathtub or
swimming pool.
5. The mounting position should be far away from bathtub, shower nozzle and
swimming pool, and make sure that people in the area of bathtub or shower
could not reach the power switch or control device of the unit.