Midea MWMTL065ZOF, Owner'S Manual

Page: 12 / 16

Cleaning and Maintenance Troubleshooting
The washing machine will send buzzer sound at the end
of every program operation to remind you to take out
the clothes or operate it again. After the sound, washing
machine returns to its power-off state with no display
and all lights off. Please turn off the tap, pull out the plug
when not in use to avoid water leakage or any accidents.
End of program
After long time usage, the water inlet mesh bag may
be blocked with mud or sand, and should be cleaned
according to the following steps:
1. Switch on the power, followed by turning off the
tap.
2. Let the washing machine work for 5 seconds so that
water flows into the tub through the water inlet
pipe, then turn off the power.
3. Unload the water inlet pipe and clean the mesh
bag.
Clean the water inlet
After using the washing machine for a period, please
clean it according to the following steps:
1. Take out the magic filter.
2. Open the filter and wash it with water
3. Restore and fix it.
Clean the magic filter
Use gentle clothing to wipe off the water and dirt from
the surface each time after using the washing machine.
Detergent, propellant and other chemicals are not
allowed to be used so as to avoid any damage to the
plastic parts.
Maintenance
When the washing machine is in trouble, please contact CMI service centre or call Midea toll free number.
No water
flows in
• If the power is off or the fuse is burned out.
• If the water supply is cut off or the water pressure is too low.
• If the inlet pipe is properly connected and the water tap is opened.
• If the filtering screen of inlet valve is blocked by dirt.
• If the coil of inlet valve is damaged. (The slight electromagnetic sound
is normal phenomenon when the inlet valve is switched on)
•
If the "Start / Pause" button is pressed after the power switch is pressed.
•
tub or the clothing is excessively placed. If the washing machine is
not placed in stable condition or it is placed in inclination state.
(The ground is not flat). If the motor belt is loose.
If the door lid is closed. If all clothing piled largely at one side of
•
•
•
If the water amount reaches to the required water level.
(The washing machine will not work if the water amount does not
required water level)
If the power is off or the fuse is burned out.
If the power supply voltage is too low.
reach the
No
Washing
•
• If the internal rubber ring of drain valve is blocked by dirt. If the water drain pipe is placed very high.
Abnormal
Draining
Abnormal
Spin
Note : During the spin process, if washing is piled at one side of the spin tub, it will cause unbalance of spin tub resulting in striking. At this moment, the
computer inside the washing machine will feel this unbalance phenomenon and will automatically correct it ( fill in water Washing ). However, if unbalance
situation is not removed after continuous corrections, which means the computer auto- correction can not resolve the problem. Then the user has to
manually and evenly place the clothing inside the tub to solve the problem.
three
20 21