Midea Tropical R410A High Efficient Duct Technical Manual 50Hz MCAC-UTSM-201707
107
minute part flashes every 0.5 seconds, then push
▲
or
▼
to adjust minute. When set clock or
alter clock setting, must push the
OK
button to complete the setting.
⑤
OK
button: The button is used at the state of clock adjustment. After select the time, push the
button to confirm then exit, the current clock will display.
⑥
RESET
button (Hidden): Use a small stick with a diameter of 1mm to push the
RESET
button,
then the wired controller will get into the condition of resetting.
⑦
ON/OFF
button: Push the button at the condition of off, the
OPERATION
lamp lights, and the
wired controller enter in to on operation, simultaneously sends the information of operation mode
set currently, temperature, fan speed, timer, etc. Push the button at the condition of on, the
OPERATION
lamp extinguishes, simultaneously sends the off. If having set timer on or timer off,
the wired controller will cancel these settings before entering into off, close the concern indicator,
and then send the off information.
⑧
FAN SPEED
button:
Select any one fan speed from ‘AUTO’, ‘LOW’, ‘MED’ and ‘HIGH’. Each
time push the button, the fan speed will change in turn as following:
⑨
TEMP
▲
button: Set indoor temperature up. If press and hold on, it will increase at 1 degree
per 0.5 second.
⑩
TEMP
▼
button: Set indoor temperature down. If press and hold on, it will decrease at 1
degree per 0.5 second.
⑪
SWING
button: Push this button for the first time when operation, it will start the swing
function. Push the button for the second time, cancel the swing function.
Notes: The function is reserved.
⑫
ECONOMICAL
button: Push the button to set the economical operation mode for air
conditioner, push again then cancel the mode. The operation mode is suitable for sleeping time.
⑬
COOL / HEAT
button (Hidden): Use a small stick with a diameter of 1mm to push the button to
switch modes. For cooling only type, it will be no heating mode when pressing
MODE
. The
uniform mode is cooling and heating at the factory.
⑭
LOCK
button (Hidden): Use a small stick with the diameter of 1mm to push the
LOCK
button
to lock the current setting, push the button again, and then cancel the setting.