background image

Special Advice:

When the water heater is working, gas combustion would consume a large amount of oxygen and exhaust much carbon monoxide. In view of the 

great harm to the human health or even death caused by excessive carbon monoxide inhalation, the company sincerely advises all users that:

 

Do not install the water heater in the bathroom;

 

Install and use the water heater strictly in accordance with the requirements stipulated in the instructions; install a smoke pipe to exhaust 

waste gases to the outdoor;

 

Make sure the room installed with the water heater has enough fresh air and is well-ventilated.

Table of Contents

Functional Features:

Functional Features……………………………………………………2
Model Instruction……………………………………………………2
External Structure……………………………………………………3

Technical Performance Parameters………………………………3

Dimensions……………………………………………………………3

Installation of the Water Heater……………………………………4

Using Methods ………………………………………………………………2
Caution ………………………………………………………………2
Troubleshooting ………………………………………………………3
Internal Wiring Diagram …………………………………………………3
Warranty ……………………………………………………………………3
Product Installation Service Card ………………………Back Cover

1.  Water Control Automatic Ignition:

 Simply open the water valve and 

the  igniter  will  ignite  automatically  with  the  hot  water  immediately 

available.

2.  Water Temperature Regulation:

 Regulate the water temperature at 

any temperature.

3.  Flue-type Exhaust Device:

 Exhaust waste gases outside to maintain 

the indoor air fresh.

4.  Season  Change:

  The  model  with  a  season  change  knob  can 

increase the adjustable outlet water temperature range by operating 

the season change knob, thus saving gas in summer.

5.  Low Water Pressure Start-up: 

Low start-up water pressure with a 

broad scope of application.

6.  Steady Water Volume:

 Effectively avoid the impact of water pressure 

fluctuation on the water volume and the outlet water temperature; and 

prevent the outlet water not hot due to too high water pressure.

7.  Flame-out Protection:

 The water heater will automatically cut off the 

gas  to  ensure  the  gas  not  leaked  when  it  flames  out  accidentally 

during the use.

8.  Water-gas Linkage Control:

 The water heater will automatically stop 

combustion and shut down when the supply of tap water is suspended 

or the water valve is shut off.

9.  Over-pressure Protection:

 When the pressure of the water supply is 

too high, the safety valve of the water heater can automatically relieve 

pressure to avoid any damage to the water heater.

10.  Anti-freezing  Protection:

  When  the  water  heater  is  used  in  cold 

areas where the outdoor temperature is below 0 °C, the anti-freezing 

drain valve is set to drain the water from the water heater to avoid any 

damage to the water heater caused by the water freezing in the water 

heater.

11.  Thermal Protection: 

The water heater will automatically cut off the 

gas and stop working when the temperature of the water flowing out 

from the water heater exceeds 90 °C or dry burning occurs. 

12.  20-minute Timing Protection:

 The water heater will automatically 

cut off the gas and power off after a 20-minute continuous operation. 

The water heater can continue working only after a restart.

*13. Outlet  Water  Temperature  Display:

  A  specific  outlet  water 

temperature display function.

 14. High Energy Efficiency Grade: 

The energy efficiency grade conforms 

to  the  requirements  of  the  National  Standards  on  Energy  Efficiency 

(GB20665-2006). The thermal efficiency of grade2 energy efficiency is 

>88% and that of grade 3 >84%. See the energy efficiency label on the 

front side of the water heater.

 

 

 

 

 

Model Instruction

 is the product code of the domestic gas instantaneous water heater;

 D is the gas exhaust mode: Flue-type; 

 represents the rated thermal load (kW);

 represents the yield capacity of the hot water (kg/min);

 represents the product serial number.

For example: JSD12-6DB represents that 
1. The product is a domestic gas instantaneous water heater;
2. The gas exhaust mode is flue-type;
3. The rated thermal load is 12kW;
4. The yield capacity of the hot water is 6kg/min; 
5. The product is a DB series product.

Note:  This manual is applicable to the flue gas water heaters (JSD*-* * *)

   

manufactured by this company.

* is peculiar to certain models.

Summary of Contents for JSQ Series














Reviews: