G
as range installation
1
~
_Z 1.NX
Gas installation
1> This range was designed for use with LP
G
gas
2> Always use a pressure regulator exclusive for your gas range.
The lack of
pressure regulator might cause excess of pressure and leak of gas.
Always
check for the validity of the pressure regulator. Hose and regulartor should
be replaced every 5 years. Technical specificaltion of the pressure regulator.
·
Pressure:
LPG
·
Max. consumption: 2kg/h
3> Always use a PVC hose to work from-20
O
C
to 100
O
C
. Be sure that hose:
·
does not have joints.
·
does not go on the back of the gas range neither close to the hot air exits.
·
Its less then 125cm long.
4> If possible, install the gas cylinder outside the kitchen, in a place protected
and
with
air flow.
5> Use a ½
metallice hose to connect to the gas range.
6> Only use a plastic hose when this one does not go on the back of the gas range.
Hose installation
1>
Leave at least 80 to 85cm between the top of the gas range and any
cabinet or
range hood install above prepared to be installed built in.
2>
Install the chain to the back of the oven;
Install the
bracket
to the back plate
(only
for some models).
3>
Make sure to not blo
c
k the oven gas exit, including the funnel or
the gas vents,
when you install the oven.
4>
The metal support must be fixed either to ensure that the heat
of the rear cover can
escape smoothly.
1> Place the metal clamp on the hose end.
2> Connect the hose to the oven inlet and tighten the clamp.
3> Place the other clamp on the oppsite hose end and connect it to the pressure regulator,
Tighten the clamp.
4> Bolt the pressure regulator to the gas cylinder carefully.
5> After the installation, check if there is any gas leak, using soap or liquid detergent foam.
6> In order to combat chain first blow a hole in the wall. Put the plastic cap on it and screw
the chain end.
Always check for the validity of the pressure regulator.
Hose and regulator should be replaced every 5 years or when it is broken.
7
2.75 KPa
chain
Bracket
